For those users who've had problems with firmware 2.030, TYT has contacted me and said that they will be issuing another firmware update "soon." Given that there are a few issues with 2.030, I'd recommend holding off on loading 2.030 and wait for the next update.
There have been some problems with the 2.30 firmware. Some of these problems are:
1 - The battery indicator always shows that the battery is fully charged
2 - If you use the radio menu to view the scan list, the radio will reboot
Tytera has acknowledged these problems and promises that an updated firmware that fixes these problems will be available soon.
The only issues that I am having with firmware 2.30 is an unreliable battery meter and the fact that the radio reboots when I try to view the scan list. I can live with both these issues and will leave 2.30 installed until a fix comes out.
Showing posts with label Tytera TYT MD380 DMR Programming Software. Show all posts
Showing posts with label Tytera TYT MD380 DMR Programming Software. Show all posts
[TYT-TYTERA] MD 380 slow scan
The shield is the encryption mode identifier, another that popped up was the speaker with an 'x', that means you muted all the system tones.
The scanning issue I circumvented by restructuring to use rxgroups for all traffic on the slot I'm on, so I have an rx group list for Slot1 and Slot2 with all TGs for each, each channel has the group Slot1 or Slot2 as appropriate. Then my scan list (which corresponds with the zone based on the channel scan group assignments I have) covers "all" but being slow doesn't matter as much as the group scan overlays it seems.
TYT-TYTERA] Unable to clear settings using CPS
This happens when the channel selector knob is set to a channel that is not programmed. Make sure you select a channel with the knob that is programmed. It will be necessary to use the CPS and program some channels if none of them are programmed.
TYT MD380 Firmware 2.32 Cps1.30
TYT MD380 Firmware 2.32 Cps1.30
Firmware 2.32 /Cps1.30 didn't solve the botom button preselection of "zone" . I programmed upper buton with scan ON/OFF : working fijne and lower one with zone selection : no action
We were having an issue and were told that it was because we used the old version of the programming software with the new firmware. Clearing the transceiver, reloading the firmware and reloading your code plug using the corresponding version of the programming software did the trick.
We programmed our units with the upper button for Power and Scan the lower for Monitor and Zone. All working fine.
Firmware 2.32 /Cps1.30 didn't solve the botom button preselection of "zone" . I programmed upper buton with scan ON/OFF : working fijne and lower one with zone selection : no action
We were having an issue and were told that it was because we used the old version of the programming software with the new firmware. Clearing the transceiver, reloading the firmware and reloading your code plug using the corresponding version of the programming software did the trick.
We programmed our units with the upper button for Power and Scan the lower for Monitor and Zone. All working fine.
MD-380 "Low" pwr. RF output too low
A friend of mine and I have found that our MD-380 HT's have in the "Low" RF output power setting ONLY 0.5 watt.
According to the manual it should be 1 watt.
Has anyone else found, using a FM signal on 440 MHz, the same?
My Firmware ver.: D002.030 CP ver.: V01.30
S/N 1505A54xxx
Could this RF output power be corrected in the firmware?